S.S. Automations

Our company manufactures and exports pH Controller, which has the facility to control a 230VAC or your required load signal whether it is a dosing pump or any other electrical load. Simply we have to do is set the lowest set point and highest set point in the controller. Then it will activate the load at low set point and deactivate the load at high set point. Our company supplies pH Controller along with Dosing Pump for pH Correction. pH Controller with Dosing Pump can be used in various process industries like boiler feed water, swimming pool etc. to control pH of water. Highest quality products are exported by us while maintaining prices of products without compromising quality of products.

Technical Specification for pH Controller

• Model : pH8A


• Range : 0-14 pH


• Maximum Input : 199 mv. DC


• Maximum Display : 1999 Counts (3 ½ digit)


• Type of Display : 3 ½ digit 7 segment LED Display


• Input Impedance : Less than 100 mega Ohm


• Accuracy : ±0.5% full scale


• Slope : 95-100%


• Response Time : 0.33 sec


• Power Supply : 230V AC, 50Hz


• Power Dissipation : 9V Amp


• Temp Compensation : pt 100 (Auto)


• Controller Output : Two inbuilt Relays


• Relay Contacts : Single NO, NC and COM


• Load : 5A@ 250V AC, 7A@ 120V AC

Sensor

• Electrode : Industrial Combined pH Glass Sensor


• Reference System : Ag/Agcl


• Reference Electrolyte : Pressurized Gel


• Pressure at 25º c : 100 psi


• Diaphragm : Ceramic


• Temperature : 0-85º C


• Housing : PVC material


• Mounting : By-Pass Line or Immersion


• Water Connection : ¼” Connector for inlet & outlet

Instrument Case:

• MOC : ABS


• Size : 90x90x150mm for Controller


• Protection : IP-65


• Mounting : Panel Board


• Power Supply : Terminal Block


• Sensor Connection : BNC Socket